Optional Rod End Boots will prolong life of rod ends by keeping road debris out of bearing surfaces and extending the life of the Teflon® bearing liner.
ATTENTION 2008-2011 MODELS:
You will need to purchase two of the following brackets linked HERE
. The supplied Prothane Polyurethane bushing is larger and has an inside width of about 2 3/16 inches. If you notice your factory piece is wider than this, you will need to purchase the control arm brackets in the link.
Looking for faster lap times? Trying to lower your 60' at the dragstrip? Then it is time to replace your weak, stamped metal factory control arms with a set of our heavy duty tubular front control arms. Manufactured from 1" x .156" wall DOM carbon tubing, they are guaranteed to outperform the factory pieces under any situation. The heim joint is a high performance unit manufactured by QA1 and polyurethane bushings are used to help maintain proper suspension geometry at all times. Powder coated black for great looks and longetivity.
These control arms are stronger and lighter than the factory pieces. The QA1 rod ends allow for a practical range of camber adjustment. There is no need to purchase camber plates with these control arms.
QA1 Rod End Features
-52100 Bearing Steel
-Hard Chrome Plated
-Black Oxide Coated
-Self-Lubricating, Teflon® Lined