JLTÂ Carbon Fiber Big Air Intake
Intake Tube with MoldedÂ MAF Housing
The best part of this JLT Big Air is we kicked the cool factor up a notch and molded a 127mm MAF housing right in the tube. This makes a much smoother interior without any transitions, steps or couplers to upset the air flow. Another benefit is the over all look is just plain awesome! Early testing shows this can be used with the stock MAF sensor all the way up to 750 RWHP and well beyond with a MAFia, SCT BA5000 or HPX sensor.
The vacuum formed ABS plastic heat shield blocks engine heat at idle and low speed. It has a weather strip that seals to the hood, and incorporates the fresh air inlet from the grill. It uses a large area to make sure the filter has tons of cool air. Now includes new redesigned heat shield so 2013 GT500's no longer have to move the intercooler pump.(2/25/13)
With a huge 5â€ť opening on the tube we needed a huge filter so we got with S&B to make us a custom filter. We love S&B's tapered flange design and Powerstack filtered ends of their filters and ended up with a monster 5x9â€ť filter, thatâ€™s a full 8.25â€ť across at the base and 5.5â€ť at the top.
Oil OR Dry
We use only the best air filters made by S&B to our specifications.
For years we only used oiled filters, but dry filter technology has been proven and is now a popular option.
Should I choose a Dry Disposable or Cotton Oiled Filter?
Since you are not sacrificing performance with either choice, the decision comes down to would you rather throw away the filter or clean it.
Comparable Airflow to oiled Cotton Filters with the same Great Protection. Last for up to 30,000 miles of highway driving. Extend the life of the filter using compressed air.
Oiled filters can last forever as long as you properly clean and re-oil it. See maintenance information below.
A JLT specific tune is required with this kit.
Real Prepreg Carbon Fiber. The best quality carbon fiber you can use!
The new design, detailed instructions and online video instructions helps make this an easy install.Install Instructions
â€˘JLT Carbon Fiber Intake Tube
â€˘5x9 S&B Powerstack White Dry Air Filter
â€˘ABS Heat Shield
â€˘HD Clamps & all needed hardware
To properly clean your Oil air filter, we recommend the S&B Precision II Cleaning & Oiling Kit.
Not C.A.R.B. approved
Custom tuning is required
CFM Performance Twin 67mm Throttle Body
The CFM Performance Twin 67mm Throttle Body is a direct replacement for both the 2007-2013 Mustang Shelby GT500 and 2011-2013 Mustang GTs with Ford Racing Supercharger Kit M-6066-MGT624D. Recently tested on a Dynojet, our Twin 67mm Throttle Body showed an increase of 37 horsepower and 26 lb.-ft. of torque on a stock 2013 Mustang Shelby GT500.
- Made in USA
- Direct replacement for 2007-2013 Mustang Shelby GT500
- Precision machined billet aluminum housing
- Custom twin 67mm bores provide maximum air flow
- OEM gears, throttle position sensor and drive motor
- Factory calibration method used for idle air flow
- Beautiful polished show finish
- Custom calibration required due to increased air flow