The JLT CAI for the 2011 V6 is a NO TUNE intake
NEW TUBE DESIGN
The new JLT tube is roto molded ABS plastic to resist engine heat and keep the intake air charge nice and cool. NO METAL TUBING HERE!!
With no separate MAF housing or couplers air flow is fast and smooth.
Automatic cars need an additional fitting, which we provide. All you need to do is drill a Ã‚Â½ hole (we show you where) in the tube, install the supplied grommet, fitting and youre done. Note, all kits sold to resellers will include the automatic fitting.
MOLDED IN MAF
Its a full 84mm ID at the MAF area
The heat shield ABS plastic to block engine heat at idle and low speed.
It incorporates the fresh air inlet from the grill.
It uses a large area to make sure the filter has tons of cool air.
GAINS AND TESTING
10-15 RWHP has been seen with this intake!
Warning, If you see more claimed by others, ask them how. Also look over the dyno sheets real good for low number baseline runs or no dyno sheets at all. Many will base line the car with 87 fuel, then add 93 fuel and the CAI to show more power. We don't do that!
Standard finish is an OEM looking black textured plastic and also available in your cars exact body color. All tubes go through an in-depth process to remove all the texture, then we use only the best quality materials to give each tube a smooth gloss finish.
JLT Textured Plastic or painted intake tube
3.5x8 S&B powerstack air filter
ABS Heat Shield
Automatic fitting kit
HD Clamps & all needed hardware
To properly clean your filter, we recommend theS&B Precision II Cleaning & Oiling Kit.
*TIP* by purchasing a 2nd air filter you can simply swap filters when it's time to clean it and not be rushed. Clean the first filter and it's ready when it's time to change again.